How do I configure my HP access point?

How do I configure my HP access point?

How do I configure my HP access point?

Configuring the computer

  1. Disconnect the computer LAN port and configure it to use a static IP address in therange 192.168. 1.2 to 192.168.
  2. Disable any wireless connection on the computer.
  3. Connect the cables:
  4. Power on the V-M200:

How do I reset my HP MSM720 controller?

To reset the controller to its factory default configuration:

  1. Using a paperclip, press and release the Reset button.
  2. Immediately press and hold the Clear button until the LEDs above the Clear button blink three times, then release the Clear button.

What is MSM controller?

The MSM controllers provide advanced Radio Resource Management (RRM), including client load balancing and interference mitigation. The MSM wireless controllers support a Fast-Roaming capability.

How do I reset my msm460 access point?

The Reset button is accessible via a hole on the bottom of the AP, labeled as 5 on page 1. Insert a paper clip into the Reset button hole. Press and quickly release the button to reset the AP. To reset the AP to factory defaults, press the button until the status lights blink three times, then release.

How do I reset my router access point?

Press and hold the Reset button of your access point for 30 seconds. Once the access point is reset, perform a powercycle. Unplug the access point’s power cable and wait for 30 seconds then plug it back in.

How do I reset my Aerohive AP?

Reset Button The reset button allows you to reboot the device or reset the AP to its factory default settings. Insert a paper clip, or something similar, into the Reset pinhole and press the reset button. To reboot the device, hold the button down between 1 and 5 seconds.

What happens when you reset an access point?

Any settings on the access point will be erased, the access point’s IP address will be set to default and the password will be “admin” after resetting.

Is the documentation on the HP msm720 controller online?

That said all the gear is typical good quality HP Stuff. The documentation consists of a “quick setup sheet” for each piece of hardware and all the manuals are Online.

What is IP address for MSM 760 controller?

Change your PC’s network card IP from DHCP to a Static IP address of 192.168.1.50 with a 255.255.255.0 Subnet Mask. Physically connect your PC’s network card to Port 2 (LAN Port) of the MSM 760 controller. Access the MSM 760 controller via a web browser at address https://192.168.1.1 Login using the default username of admin and password of admin.

What do you need to know about hp MSM wireless?

With the addition of an HP MSM wireless network, the customer wants to provide two different wireless networks: a Private wireless network, and a Public wireless network. The following highlights the design goals for each particular wireless network that will be implemented:

What are the steps in deploying MSM wireless?

Allow any wireless device on the Public wireless network. No data encryption – for easier client configuration. Prevent guest users from accessing ANY network resources – ONLY allow direct internet access. Enable a splash page that forces guest users to authenticate before given access to browse the internet.