How do I check my ip sla?

How do I check my ip sla?

How do I check my ip sla?

To display the status of IP Service Level Agreements (SLAs) auto discovery and the configuration of auto IP SLAs endpoint lists configured to use auto discovery, use the show ip sla auto discovery command in user EXEC or privileged EXEC mode.

What is the default SLA monitoring interval towards controller?

The default interval between packets is 20 ms.

How do I run ip sla?

Defining and Running an IP SLA Test Operation

  1. Step 1: Enable the IP SLA Responder on the Target Switch. Switch(config)# ip sla responder.
  2. Step 2: Define a New IP SLA Operation on the Source Switch.
  3. Step 3: Select the Type of Test Operation to Perform.
  4. Step 4: Schedule the Test Operation.

What is ip sla probe?

The IP SLAs Probe Enhancements feature is an application-aware synthetic operation agent that monitors network performance by measuring response time, network resource availability, application performance, jitter (interpacket delay variance), connect time, throughput, and packet loss.

How do I clear IP SLA?

IP SLA- How to Restart or Clear Counters of IP SLA Statistics

  1. R1(config)#ip sla monitor restart 1 >>>>> where “1” is Entry number.
  2. R1(config)#ip sla restart 1 >>>>> where “1” is Entry number.
  3. Round trip time (RTT) Index 1Latest RTT: 2 milliseconds.
  4. Round trip time (RTT) Index 1Latest RTT: 2 milliseconds.

How do I restart IP SLA?

How to show IP SLA in Cisco IOS?

show ip sla auto group To display configuration values including all defaults for all Cisco IOS IP Service Level Agreements (SLAs) auto-measure groups or a specified group, use the showipslaautogroup command in user EXEC or privileged EXEC mode. show ip sla auto group [ type ip [group-name] ]

How to create serial number of IP SLAs operation?

Serial number of IP SLAs operation created for specified endpoint. Entry number of IP SLAs operation created for specified endpoint. Type of IP SLAs operation created for specified endpoint. IP address and port of destination for operation in current display. Command Description

What happens to IP SLA when ICMP echoes are not replied?

When our IP SLA ICMP echoes are replied, the “successes” counter will increase. When we don’t get a reply to our ICMP echoes then the “failures” counter will increase: The most simple way to simulate a failure is to shut one of the interfaces.

How to simulate a failure with IP SLA?

The most simple way to simulate a failure is to shut one of the interfaces. You can also configure IP SLA so that it will trigger a failure when certain thresholds are exceeded (for example when the RTT exceeds a certain value).