How do I connect my HP ProCurve switch?

How do I connect my HP ProCurve switch?

How do I connect my HP ProCurve switch?

To connect a console to the switch, use the console cable shipped with the switch and connect a PC or VT-100 terminal to the console serial port. The PC or terminal then functions as a management console connected directly to the switch.

How do I turn off HP ProCurve switch?

The only way to completely shut down the switch is by pulling the power plug. This is by design. Since the switch can only be powered off through physical intervention, it negates the risk of someone inadvertently issuing a command to shut it down remotely.

How do you reset a ProCurve switch?

To execute the factory default reset on the switch, perform these steps:

  1. Using pointed objects, simultaneously press both the Reset and Clear buttons on the front of the switch.
  2. Continue to press the Clear button while releasing the Reset button.
  3. When the Self Test LED begins to blink, release the Clear button.

What is the default password for HP ProCurve switch?

NO default password is set when the switch is new. The default configuration is quit simple: One default Vlan (Vlan1) with IP DHCP enabled on this Vlan, and it has 2 users built in: Manager & Operator with NO password set but you can configure other user names (Optional).

How do I setup my HP switch?

How to: Configure a HP ProCurve switch

  1. Step 1: Connect your serial connection.
  2. Step 2: Conenct PuTTY.
  3. Step 3: Get the IP address.
  4. Step 4: Set time server.
  5. Step 5: Set SNMP community info.
  6. Step 6: Launch the web GUI.
  7. Step 7: Configure basic info.
  8. Step 8: Create VLANs.

How do I configure my HP switch?

To do so, do one of the following:

  1. Enter setup at the CLI Manager level prompt. HP Switch# setup.
  2. Select Run Setup in the Main Menu of the menu interface.

How do I check my ports on my HP switch?

To check the mode setting for a port on the switch, use either the Port Status screen in the menu interface or show interfaces brief in the CLI (see Viewing port status and configuration (CLI)).

How do I enable Poe on my HP switch?

To configure a port by value:

  1. Set the PoE allocation by entering the poe-allocate-by value command: HP Switch(config) # int A6 poe-allocate-by value. or in interface context: HP Switch(eth-A6) # poe-allocate-by value.
  2. Select a value: HP Switch(config) # int A6 poe-value 15. or in interface context:

How do I restart my HP switch?

Solution

  1. Press the small, recessed Reset button on the face of the switch.
  2. Issue the command, reload from within the CLI.
  3. Or, issue the command, boot system flash to reboot into either primary or secondary flash.
  4. Or, unplug the switch for at least 10 seconds in order to cold boot the device.

How do you Reset a 2530 switch?

Using pointed objects, simultaneously press both the Reset and Clear buttons on the front of the switch. The power and fault lights come on. Continue to press the Clear button while releasing the Reset button. When the Self Test LED begins to blink, release the Clear button.

How do I log into my HP ProCurve Switch?

Log into your ProCurve using SSH or Telnet. Select Run Setup in the menu either by hitting 8 or using the arrow keys then hitting enter. Using the arrow keys, select Logon Default. Hit space to change Logon Default to CLI.

How do I clear my HP password?

Open windows Control Panel, in the top right of this window click the dropdown menu for ‘View by’ and select Large Icons. Now click User Accounts, click the Remove password link, enter the current password and then click the ‘Remove Password’ button.