How do I setup my Tenda wireless router as an access point?

How do I setup my Tenda wireless router as an access point?

How to change a Tenda router to AP mode

1. Connect a computer to the Tenda router and launch a web browser.
2. Visit the following router configuration page: http://192.168.0.254.
3. You are prompted to enter a username and password.
4. Click Wireless Settings, then clickWireless Basic Settings to choose AP mode.
5. Click Ok.

How do I access my Tenda access point?

Open up a web browser and type 192.168. 0.254 into the address bar. Press enter. You will now be on the login page.

How do I find the password for my wireless access point?

In Wi-Fi Status, select Wireless Properties. In Wireless Network Properties, select the Security tab, then select the Show characters check box. Your Wi-Fi network password is displayed in the Network security key box.

What is access point in WiFi?

An access point is a device that creates a wireless local area network, or WLAN, usually in an office or large building. An access point connects to a wired router, switch, or hub via an Ethernet cable, and projects a Wi-Fi signal to a designated area.

How do I reset my Tenda access point?

How to factory reset the Tenda W301A Access Point

1. On the back of the access point, press and hold the RST button for more than seven seconds.
2. That is all there is to it. The access point will complete its reset in just a few minutes.

Does Access Point have IP address?

1 Answer. Wifi access points need not have an IP address, any more than wired switches and hubs do. However a large number do, as they also act on the IP layer as DHCP servers and network gateways.

How do I know if my Access Point is working?

Open a Command Prompt window on a PC on your wired network and ping your wireless access point’s IP address. The wireless access point should respond to the ping. If it doesn’t, there’s either a break in the communications link or the access point is completely malfunctioning.