How do you complete a Ford drive cycle?

How do you complete a Ford drive cycle?

Idle the vehicle in Drive for 1 minute. Drive at 25 mph and drive for 15 minutes at speeds between 15-35 mph. Within this time, stop at least 5 times, and have at least 3 periods of steady speed for 90 second durations. Drive the vehicle between 45-60mph for 8 minutes.

How long does it take to complete a full drive cycle?

How Long does it Take to Complete a Drive Cycle. Preparation for it will take eight hours but, all in all, a basic drive cycle test should take around 30 minutes to complete, with about 20 minutes of actual driving. Understanding your vehicle’s overall health can help you ensure it drives smooth and lasts long.

What is a drive cycle Ford?

A drive cycle is one of the methods used by a vehicle’s powertrain control module (PCM) to determine whether an emissions system repair was performed successfully. It involves a special test drive that duplicates the scenario of a person starting the car and making a short freeway trip, as if driving to work.

How do you do a drive cycle for inspection?

15 minutes of steady driving on an expressway/highway followed by 20 minutes of stop-and-go driving with at least four 30-second idle periods. Allow the vehicle to sit for at least eight hours without starting the engine. Then, start the engine and complete the above driving cycle.

How many miles do you have to drive to reset your car computer?

Here’s something you probably don’t know: after clearing the car’s computer you will need to drive for about 50 to 100 miles. As you drive your car the computer will monitor all the sensors and register the results. You can use GOFAR to constantly monitor your car diagnostics.

How long do Pending codes last?

After 3 consecutive drive cycles, when the ECM no longer detects a fault(s), the MIL (malfunction indicator lamp/check engine light) will turn off. Pending Trouble Code Clearance… Type A code – Code will remain pending until 80 warm up cycles.

How long does battery need to be disconnected to reset ECU?

Disconnecting the battery for a short time may not do the trick because the car’s computer, or ECU, still has some current in it. Waiting for over 15 minutes after disconnecting the engine will help ensure the equipment is reset.