What does service brake visit workshop mean?

What does service brake visit workshop mean?

This is a fairly broad message. It simply means there is a problem with the braking system in general and it should be addressed by a Mercedes-Benz technician. Most commonly, we see this message in the Mercedes-Benz E-Class.

What does it mean when Mercedes says visit workshop?

The first one is the message that reads “Visit Workshop!” which simply just means that it is time for your next service. The other message is the picture of the car with the arrow pointing up which is an indication there is something malfunctioning with your Airmatic suspension.

What is SBC pump Mercedes?

The Sensotronic Brake Control (SBC) system is fitted to many Mercedes-Benz vehicles ranging from 2001-2011. A piston pump driven by an electric motor supplies a controlled brake fluid pressure between 140 and 180 Bar in the gas diaphragm reservoir (Accumulator).

How do you reset the battery on a Mercedes workshop?

Here is a simple test you can perform if you get Battery Defective message at start up. Let the car run for about 10 -15 minutes. Then go turn off the car, make sure all the light are off and nothing is on for a 30 seconds or so. Then start your car back up again.

How do I know if it’s the alternator or the battery?

An illuminated dashboard light can indicate a problem with an automobile charging system. However, a very simple way to check if the alternator is working is to run the car and disconnect the positive terminal of the battery. If the vehicle stops running, then you probably have a bad alternator.

Why does my car say visit workshop?

Typically you get BATTERY/ALTERNATOR VISIT WORKSHOP warning when the electrical system voltage in the car is below 12.6 volt. If you have a multimeter like this one, you can connect it to the battery terminals to get a voltage reading.

How do you check a brake light switch on a Mercedes?

Locate brake light stop switch The brake light switch is located right above the brake pedal. To access it, remove the underside panel cover. Usually, the panel is held in place with 3 to 5 screws. Mercedes-Benz uses Torx head screws.

When did Mercedes stop using SBC?

MB stopped fitting pumps to cars manufactured during 2006.

What does auxiliary battery malfunction mean on a Mercedes?

If this auxiliary battery develops a malfunction, it will show up as an error message on the dashboard. You will know that it’s the secondary battery that is at fault, because the car will still turn on and some functions will still work. The auxiliary battery does not affect the car’s mechanical functions.