What oil to use with a yukon grizzly locker?

What oil to use with a yukon grizzly locker?

Yukon recommends non-synthetic 80W-90 GL-5 gear oil in all differentials. Oil is rated by its viscosity value.

How does a Yukon Zip Locker work?

Typically an air locker system is controlled by a dash mounted switch board. Once activated, compressed air via the compressor is sent through an air line into the differential. The compressed air enters the locker’s piston which actuates the gear that locks the axle.

How does a grizzly locker work?

Grizzly Lockers provide 100% power to both tires, while still allowing for disengagement while negotiating turns. The Yukon Grizzly locker is a mechanical locking differential. It features a forged case and 8620 internals for maximum strength. It’s patented design reduces common locker failures.

Does a Detroit Locker need additive?

Do I need friction additive/modifier? A quality petroleum/mineral based oil works best in the Detroit Locker units. Friction additive/modifier is not required.

How does an ARB Air Locker work?

The ARB Air Locker uses a small charge of air from an on board air compressor that in turn activates the locker. When activated, both axle shafts are locked together into the equivalent of a spool providing 100% equal traction to both wheels of that axle with no differential of speed between the wheels of that axle.

Is a G80 a locker?

The Eaton (eaton.com) G80, also known as the Gov-Loc is a true automatic locker, not a limited-slip differential. It has been an available option on GM trucks for decades. The unit automatically engages when the speed difference between the two tires on the same axle reaches 100 rpm.

Are there grizzly bears in the Yukon?

What kind of bears live in the Yukon? Our territory is home to Grizzly bears, Black bears, and in the far north, majestic Polar bears. Grizzlies are brown-blonde and can weigh up to 800 pounds. Black bears are brownish-black, and can weigh up to 400 pounds.

How to install Yukon gear Grizzly Locker rear differential?

Wipe all surfaces with a clean rag dampened with either fresh oil or solvent to remove any metal particles. When assembling internal components, coat all bearings, and seal surfaces with fresh gear oil. Never use bearing grease on pinion or carrier bearings; it will negatively influence assembly readings.

How do you install gear on a Yukon?

1. Ensure that you have everything you need before working. Verify whether all new parts match the application and parts invoice. 2. Lift the vehicle using an appropriate lift or jack, and support the vehicle with approved jack stands. Never work on an unsupported vehicle. 3. Drain used gear oil into a suitable container.

How to install Yukon gear Dana 30 pinion kit?

Coat three or four ring-gear teeth in at least two places with a moderate amount of compound and rotate the ring gear four or five times around the pinion gear in both directions. Rotate by grabing and turning the ring gear, not the pinion. Pinion resistance against the rotating ring gear helps establish a good pattern.