Why is my generator pull cord stuck?

Why is my generator pull cord stuck?

Broken or worn-out friction (drive) plate If broken or worn out, the pull cord may not move in and out of the pulley freely and may even get stuck either inside or when pulled out. To check this part of the starter, you’ll have to remove the starter. If it’s broken, you’ll likely see it straight away.

Why can’t I pull the cord on my leaf blower?

The leaf blower pull cord that is stuck can be repaired by fixing one of the following problems: The pull cord has gotten tangled or damaged. Oil is trapped in the leaf blower’s combustion chamber causing a hydro lock. Spring inside the pull starter assembly is not working properly.

Why can’t I pull start my generator?

If there is no spark or if the spark appears weak, remove the spark plug and cap. Put the end of the spark plug wire near the engine’s body and pull the recoil starter to check the ignition coil. If there are now sparks appearing between the spark plug boot and engine, then the spark plug needs to be replaced.

How do you unstick a lawn mower pull cord?

Sometimes the pull cord crosses over itself when rewinding, and when this happens, it can get stuck. You may be able to free it by pulling it gently to coax it out to its full length, then letting it rewind slowly.

What should I do if my Ryobi cord won’t pull?

Ryobi s430 cord wont pull. Movers handled trimmer in move and may have stored upside down. Removed spark plug and cord pulls. Put plug … read more

Why is the cord on my Ryobi weed wacker not working?

Ryobi s430 cord wont pull. Movers handled trimmer in move and may have stored upside down. Removed spark plug and cord pulls. Put plug … read more I purchased a Ryobi s430 weed wacker from Home Depot Used it once and now it smokes badly and will not continue to run. Now I cannot get it to start. … read more

Can a Ryobi S430 4 cycle engine start?

S430 4 cycle I took out the spark plug and Tried starting ryobi and can’t get cord to pull. Let me Hi, the engine starts but will only run for about 30 seconds with a minimum of half choke. Have changed spark plug, replaced gas filter, both fuel … read more I have ryobi 25cc 2 cycle power head. I got started but head

How do you replace pull string on Ryobi Weed Eater?

Hold the pulley firmly and do not release. Insert one end of the replacement string through the hole in the starter handle, tie an overhand knot in the end, and pull the knot down against the handle. Insert the free end of the replacement string through the hole in the housing and the hole in the pulley.