What is metal trim?

What is metal trim?

Metal roof trim is used to seal joints and direct water away from the building, protecting the structure from moisture damage. This can occur wherever two roof panels come together, form a valley or intersection, or at the edge line where metal roof panels meet the endwall panels. Metal Trims. Color & Shape Chart.

How thick is metal trim?

Most metal roof and metal siding panels on the market are between 20- 29 gauge, with 20-gauge being the thickest and 29-gauge being the thinnest panels sold. These numbers refer to the decimal thickness of the steel and they have a range. For Example, 26 gauge could be a steel as light as .

What is metal eave trim?

Eave trim is the metal flashing that covers the low side of the building. Simply put, it’s installed on the side of the building that follows the pitch of the roof. Eave trim is used when a gutter is not required. Eave trim is also referred to as drip edge or eave flashing.

What is the metal trim around a roof called?

Drip edges
Drip edges are metal sheets, usually shaped like an “L,” installed at the edge of the roof. Also called drip edge flashing or D-metal, they serve a vital function by directing water away from the fascia and into the gutter.

What is rake trim on a metal roof?

Rake trim (also known as gable trim) is a metal flashing finishing piece placed along the roofline at the sloped sides at the end of a residence’s dormer or gable. Rake trim can be flat with no overhang, or it can overhang the gable end like an eave.

Does a metal roof need a drip edge?

A drip edge is not needed for metal roofing. If you make sure to overhang your metal roofing at least an inch, the drip edge is not necessary at the eaves and rakes. If the metal roof is hanging over an inch, the water will be directed away from the fascia anyway if at a slant.

What goes on the sides of a metal roof?

Soffit — The panels or material that connect a roof’s overhang to the side of a building. Valley — The valley of a metal roof is the internal angle, formed by an intersection where two sloping planes meet, which provides water runoff. Typically, the eaves project beyond the side of the building.

What is the difference between rake trim and gable trim?

Rake: The inclined edge of a sloped roof over a wall from the eave to the ridge. These two slopes meet at the peak or ridge. Trim that goes on these slopes is referred to as “gable or rake trim”. We typically use the term “gable trim”.

What kind of trim does worldwide steel buildings use?

Worldwide Steel Buildings offers the top sheet metal panels, metal roof panels and trim in the industry. Because even our sheet metal panels and trim are incredibly customizable, you can include them in your metal building kit and still get the building look you’ve been dreaming about.

Where can I get metal panel trim for my roof?

Download Spanish installation manuals of MBCI’s standing seam roof panels. Discover the nearest MBCI location to learn about our products and services. MBCI offers a wide range of custom metal panel trim products for roofing, façade and non-load bearing walls for all industries.

How big do metal panel roofing panels get?

Metal Panels Inc. manufactures a wide selection of custom trim up to 21 ft. in length for standing seam and through-fastener metal panel roofing and buildings. Our trim is typically a heavier gauge than offered elsewhere, to resist warps and dings, and increase installed durability.

Why is it important to use metal trim on metal building?

That means no matter what you use for siding and trim on your metal building, the strength comes from what’s inside. However, the roofing and siding you choose are important as well. They keep what’s inside your building protected, keep the elements and pests out, and handle snow and wind loads.