What is ASTM d3350?

What is ASTM d3350?

This specification covers the identification of polyethylene plastic pipe and fitting materials. Color and ultraviolet stabilizer, thermal stability, brittleness temperature, density, tensile strength at yield, and elongation at break shall conform to this specification.

What is ASTM F714?

ASTM F714: Standard Specification for Polyethylene (PE) Plastic Pipe (SDR-PR) Based on Outside Diameter.

What is ASTM d2737?

Standard Specification for Polyethylene (PE) Plastic Tubing This specification covers polyethylene (PE) tubing pressure-rated for water. sustained pressure, hydrostatic burst pressure, and environmental stress cracking.

How do I choose a HDPE pipe?

HDPE pipes material selection and applications. Characteristics which are normally considered while selecting a grade are density, molecular weight distribution, comonomer (type and content ), thermal stabilisation and UV stabilisation.

What is SDR 11 pipe used for?

Standard dimension ratio (SDR) is a method of rating a pipe’s durability against pressure. The standard dimension ratio describes the correlation between the pipe dimension and the thickness of the pipe wall. Common nominations are SDR11, SDR17 and SDR35. Pipes with a lower SDR can withstand higher pressures.

What is the d3035 specification for plastic pipe?

D3035 Specification for Polyethylene (PE) Plastic Pipe (DR-PR) Based on Controlled Outside Diameter D4218 Test Method for Determination of Carbon Black Content in Polyethylene Compounds By the Muffle-Furnace Technique D4703 Practice for Compression Molding Thermoplastic Materials into Test Specimens, Plaques, or Sheets

Which is the active standard for polyethylene pipe?

Active Standard ASTM D3350 | Developed by Subcommittee: D20.15 Book of Standards Volume: 08.02 This specification covers the identification of polyethylene plastic pipe and fitting materials.

What’s the working pressure of a HDPE pipe?

SDR 11 (STANDARD DIMENSION RATIO) 160 PSI (WORKING PRESSURE AT 73.4°F) Molded of PE 100/4710/3408 Black SDR 17 (STANDARD DIMENSION RATIO) 100 PSI (WORKING PRESSURE AT 73.4°F) Butt End Caps (Elongated)

How is the density of a polyethylene pipe determined?

D2839 Practice for Use of a Melt Index Strand for Determining Density of Polyethylene D3035 Specification for Polyethylene (PE) Plastic Pipe (DR-PR) Based on Controlled Outside Diameter D4218 Test Method for Determination of Carbon Black Content in Polyethylene Compounds By the Muffle-Furnace Technique