What does F1 mean on a Whirlpool washer?

What does F1 mean on a Whirlpool washer?

Usually, it’s a problem with the control board. By replacing the control board, you should be able to fix the problem. However, it might also be a problem with the hose, something might be stuck in the hose. There is even a web site dedicated to the F1 error 🙂 Whirlpool F1 Error web site.

How do you fix the F code on a Whirlpool Cabrio washer?

DIY Repair

1. Unplug the washing machine for 2 minutes and then plug it back (it will help the appliance re-conduct self-diagnostics and conclude that there is no breakdown);
2. Press the START and PAUSE buttons simultaneously and hold them for 1 minute to clear the error code.

What does F1 error mean?

These errors generally mean the control board has failed in one or more ways. F1 is by far the most prevalent. When this happens you need to replace the control board.

What does Error Code F mean on Whirlpool washer?

The F/dL code indicates a door lock error on the machine. When the door fails to lock to allow the cycle to begin, it attempts to lock itself at least six times before the error appears on the digital display screen. When the door fails to lock, the machine won’t run at all.

What does F1 code on Whirlpool Cabrio washer mean?

The F1 error code on a Whirpool Cabrio washer means that water level pressure switch that is built into the computer board on those models is sending an incorrect signal to the board.

What does Code F mean on a whirlpool washer?

Whirlpool Duet washing machine error codes are seen on the digital display as: F# and E# OR just as F#. The “F” error code indicates the washing machine system or “Fault”. Ehe “E” error is indicating the part in your washer that causing the issue or “Error”.

What does F1 mean on a whirlpool dryer?

The “F1” error means that the dryer’s thermistor failed. The dryer is reading the thermistor as “open” and the actual part has shorted out.

What does Whirlpool Cabrio F1 error code mean?

Whirlpool Cabrio Washer Error F1. The Cabrio Washer F1 error code happens when the main control board gets a bad signal from the water level pressure switch circuit. This is normally caused by a pinched or ripped water level pressure switch hose. Steps to take to try and remedy this error are listed below.